国产精品日韩欧美一区二区三区,欧美内射深喉中文字幕,国产一二三精品无码不卡日本,国产亚洲精品久久久久婷婷瑜伽,三级强伦姧在线播放,国产69精品久久久久人妻,巜人妻公妇の浮中字,处破女八A片60钟粉嫩,久久人妻熟女中文字幕AV蜜芽,亚洲精品久久久久久动漫器材一区

Safety control regulation for hollow blow molding machine

First, start hollow blow molding machine

1) rotate the hollow blow molding machine clockwise, and the main power switch of the single screw extruder will rotate from the horizontal state (OFF state) to the vertical state (ON state).

2) press the green power button on the control panel of the extruder to start the extruder.

3) press the blue reset button (R) on the control panel of the blow molding machine.

4) turn the power switch on the control panel on the hollow blow molding machine clockwise, and turn it from the closed position to the open position.

5) set the temperature of each part of the extruder barrel on the extruder control panel.

6) set the temperature of each part of the die on the control panel of the blow molding machine.

7) set the parameters of the blowing bottle on the touch screen of the blow molding machine.

8) add material into the funnel of the extruder and rotate the hopper to the feeding position.

9) when all parts reach the set temperature, wait for about 15 minutes to ensure the temperature is stable.

10) according to the green start button on the extruder control panel, the start screw, the screw speed control knob on the control panel of the rotating extruder, and the rotating speed of the screw are set.

11) press the green start button on the control panel of the hollow blow molding machine to start the motor pump.

12) turn the mode selector switch on the control panel of the blow molding machine, and complete the automatic operation mode.

13) after the material flowing out of the mold head reaches the right length, press the green start button on the control panel of the blow molding machine to start the bottle blowing cycle.

Two. Closed hollow blow molding machine

1) after the bottle blowing cycle is finished, press the red stop button on the control panel of the blow molding machine to stop the motor pump.

2) screw the extruder funnel to the stop position.

3) after the extrusion of the material in the extruder barrel, the screw speed control knob on the control panel of the extruder is controlled. The rotating speed of the extruder screw is set to zero, and the red stop button on the extruder's control panel is pressed and the screw is stopped.

4) turn the power switch on the control panel of the blow molding machine counterclockwise, and turn it from the open position to the position.

5) press the red power button on the control panel of the extruder to stop the extruder.

6) rotate the hollow blow molding machine counterclockwise, and the main power switch of the single screw extruder will rotate from the vertical state (ON state) to the horizontal state (OFF state).

Three. Attention to matters

Do not use emergency devices (emergency stop button) to stop the equipment when used normally.